Obi-Wan Kenobi on Boga 3D Printed Diorama, Unpainted Star Wars Model Kit

You are a bold one! Leap into action with this Obi-Wan Kenobi on Boga 3D Printed Figure / Diorama, a spectacular tribute to one of the most memorable and thrilling sequences from.

Star Wars: Episode III - Revenge of the Sith. Obi-Wan Kenobi, the wise and formidable Jedi Master, found himself deep within the sinkholes of Utapau during the Clone Wars, tasked with confronting the insidious General Grievous. It was there he encountered Boga, a loyal and swift varactyl, a reptilian creature native to the planet. After a daring leap onto her back, Obi-Wan and Boga forged an incredible bond, becoming an unstoppable duo in pursuit of the Separatist commander. The figures are printed in high-quality gray or black resin to enhance detail visibility.

Additional painting supplies may be required. About the Printing: Our figures are printed on 4K Sla 3d printers, with. 04 layer height to give you a high clarity/resolution. To reduce the cost of the figure some models are hollowed, Wall thickness Will be 2 mm. A Printed model is S(1/16) - 262 mm Tall ; M(1/10) - 420 mm Tall; L(1/6) - 700 mm Tall.

Sizes are calculated from the start of the base to the last point of a figure. If would like to get a custom size please send a message. We will try to make sure those markings are as minimal as possible, Some components may need a little sending for a perfect Fit. Although all our statues are cured and safe to the touch.

Please do not eat or place statues in your mouth, as uncured resin may be inside still. Do not allow around small children either.

This modal is brought to you by Star Wars 3D Models Studio. We are authorized to sell physical prints of the artist's models.

Check my store for more figures like this, hope you will find the figure for your collection.