B1 Battle Droid 3D Printed Figure, Star Wars Combat Droid, Unpainted
The B1 Battle Droid was the primary infantry unit used by the Separatist Alliance during the Clone Wars in. Mass-produced by the Techno Union and Trade Federation, these skeletal droids were cheap, obedient, and deployed in massive numbers against the Jedi-led clone forces of the Republic. Though lacking in intelligence and durability, B1s became iconic for their quirky dialogue, clumsy behavior, and comedic presence, especially in. The figures are printed in high-quality gray or black resin to enhance detail visibility. Additional painting supplies may be required.
About the Printing: Our figures are printed on 4K Sla 3d printers, with. 04 layer height to give you a high clarity/resolution. To reduce the cost of the figure some models are hollowed, Wall thickness Will be 2 mm. A Printed model is S(1/16) - 127 mm Tall ; M(1/10) - 204 mm Tall; L(1/6) - 340 mm Tall.
Sizes are calculated from start of the base to the last point of a figure. If would like to get custom size please send a message.We will try to make sure those markings are as minimal as possible, Some components may need a little sending for a perfect Fit. Although all our statues are cured and safe to the touch. Please do not eat or place statues in your mouth, as uncured resin may be inside still. Do not allow around small children either.
This modal is brought to you by Star Wars 3D Models Studio. We are authorized to sell physical prints of the artist's models. Check my store for more figures like this, hope you will find the figure for your collection.